Prints Go Haywire after starting

Post your tips here to help more users.

Prints Go Haywire after starting

Postby TinGeneral  » Sun Jan 21, 2018 1:59 pm

Just started printing with my new pro. my prints ( even the demo's supplied by XYZ) start out fine then about half way through they become just random string and a ball of PLA. It is like it forgot what it was printing and just threw filament at it. Any suggestions on this problem?
TinGeneral 
New Arrival
 
Posts: 1
Joined: Sun Jan 21, 2018 1:54 pm

Re: Prints Go Haywire after starting

Postby jason jason » Thu Mar 22, 2018 10:01 am

You may be suffering from layer shifting. Can you post a pic? Have you solved this? I will try to help, I need more info.
jason jason
Apprentice
 
Posts: 67
Joined: Thu Mar 22, 2018 9:28 am

Re: Prints Go Haywire after starting

Postby txdo_msk » Fri Mar 23, 2018 7:10 pm

Been a while since I printed, but when i was doing a lot, I kept getting spaghetti ptints whenever i had it down in my basement in Winter. Turned out it was too cold even for the enclosed space in my Jr W.
txdo_msk
New Arrival
 
Posts: 3
Joined: Thu Mar 22, 2018 6:19 pm

Re: Prints Go Haywire after starting

Postby jason jason » Thu Mar 29, 2018 4:05 am

If you have any more problems, pls don't hesitate to post again. Also if you find a solution, it's always helpful to post that answer, so that it may help others. :)
jason jason
Apprentice
 
Posts: 67
Joined: Thu Mar 22, 2018 9:28 am


Return to Tips & Tutorials

Who is online

Users browsing this forum: No registered users and 1 guest

cron