Printing under the table

Post any question related to da Vinci series printers here.

Printing under the table

Postby Krzysztof » Sun May 27, 2018 11:21 pm

Hello,
Since version 1.1.22.1 there is still a problem with printing under the table, now another firmware and the same problem!
Will anyone do something about it!
you can also see a problem with the layer height above the slide, below it is correct 0.15 and above is around 0.2 or more.
I shipped a few times about this problem since version 1.1.22.1 but I see that this one is not able to take care of, and perhaps no one knows how to do that.
I remind you that there is no problem in version 1.1.21.1!
https://zapodaj.net/8c0b5b17468ab.jpg.html
https://zapodaj.net/47905fa1b3c8e.jpg.html
Krzysztof
New Arrival
 
Posts: 1
Joined: Sun May 27, 2018 11:16 pm

Return to da Vinci Series

Who is online

Users browsing this forum: No registered users and 2 guests

cron